Hello!
My remote works and the LED is blinking when remote button is pressed. But no matter which mode I’m in, no power I being emitted through D0-D3?
I keep seeing the same comment: the remote works and the receiver LED blinks, but D0-D3 seem to have no output.
Are you also experiencing the same problem?
D0-D3 are signal outputs, not power rails. The manual gives a maximum output current of 10 mA, so don’t connect a relay coil, lamp, or motor directly.
To check the signal, re-pair at DC 3V-5V, choose a mode, and disconnect the load. Measure D0 to GND before, during, and after a button press.
Which signal result do you get: no change, a change only while pressed, or a change that stays after release?
Manual: RX480E-4C